JWP digital weighing scales operation manual
REV: C1, June 2012
JWP digital weighing scales operation manual
As the battery is used it may fail to hold a full charge. If the battery life
becomes unacceptable then contact your distributor.
Note: new batteries are shipped partially charged. Before you can use
your scale, you need to install and charge the battery, as indicated by the
following instructions.
Some batteries perform best after several full charge/discharge cycles.
Battery performance depends on many factors, including your backlight
setting and operate.
9 CALIBRATION
Turn on the scale and press
%
and
TARE
key during the self test..
Display will be shown
”UNLOAD”
Remove all weight from the platform.
Press
ZERO
to confirm when display gets stable.
Display will be show previous calibration weight and start to blink first
digit, if necessary enter the calibration weight value by pressing
LIM
and
TARE
keys.“10.000”
Press
ZERO
to confirm, display will be show
”LOAD”
Place the load on the platform.
Press
ZERO
to confirm when display gets stable.
Calibration will be finish and will start to self test to come normal
weighing.
Note: Calibration weight should be 1/3
rd
of the scale capacity.
-10-
Contents
1 INTRODUCTION……………………………………………………1
2 KEY DESCRIPTIONS………………………………………….……2
3 BASIC OPERATION…………………………………………….…..3
3.2 Taring……………………………………………………..…….3
3.3 Weighing a sample……………………………..…………….4
4 PRECENT WEIGHING………………………………………...…….4
5 PARTS COUNTING………………………………………..…..…….7
6 CHECK-
WEIGHING………..…………………………………..…….7
7 ACCUMULATED TOTAL………..……………………………….….7
7.1Manual accumulation………..………………………….…….8
7.2 Automatic accumulation……..……………………………...8
8 BATTERY OPERATION………………………………..………..….9
9 CALIBRATION
………………………………..………….……..….10
Summary of Contents for JWP
Page 1: ...JWP Weighing Scales ...
