T28 w eighing scales operat ion manual
REV C1, June 2012
T28 w eighing scales operat ion manual
CONTENTS
1. Introduction…………………………….…………………….….…...……1
2. Key descriptions……………………………….….…………………….…1
3. Displays…………….……………………………….……………….…….1
4. Operation…………………………….………………………………….…1
4.1 Zero the scale……………………….……………………………….….1
4.2 Tare………………………………………..………………………………2
4.3 Change weighing unit……………………………………………………2
5. Parameters & calibration….……………………….………………….…3
5.1 Enter setting mode………………………………………………………..3
5.2 Calibrate…………………………………………………………………3
5.3 Change resolution
………………………………………………………3
5.4 Check internal counts………………………………………………….3
5.5 Set
backlight mode……………………………………………………..4
5.6 Set the second unit
……………………………………………………4
5.7
Set auto power off………………………………………………………4
5.8 Change capacity
………………………………………………………….4
5.9 Set auto zero tracking
…………………………………………………4
5.10 Set A/D speed
……………………………………………………………5
6 Battery operation
……………………………………………………………5
5.10 Set A/D speed
A
fter enter setting mode, display shows “
F0 CAL
”, press
ZERO
key
eight
times, display shows “
F8 SPD
”, press
TARE/UNIT
key to enter,
press
ZERO
key select the A/D speed (7.5, 15, 30), press
TARE/UNIT
key to sure, press
TARE/UNIT
key and
ZERO
key at the same time to
escape.
6. BATTERY OPERATION
When battery voltage low, the indication will turn on. The battery
should be charged as soon as the arrow is on. To charge the battery
simply plug into the AC adapter. The scale does not need to be turned
on.
There is an LED above display window to indicate the status of
battery charging. If the LED is green the battery has a full charge. If it
is red indicates the battery is being charged.
As the battery is used it may fail to hold a full charge. If the battery
life becomes unacceptable then contact your distributor.
-5-
Summary of Contents for T28
Page 1: ...T28 Weighing Scales...
