DSC Q Series Getting Started Guide
47
Using the DSC
All of your DSC experiments will have the following general outline. In some cases, not all of these steps will
be performed. The majority of these steps are performed using the instrument control software. The instructions
needed to perform these actions can be found in the online help in the instrument control program; therefore,
they will not all be covered in detail here.
•
Calibrating the instrument
•
Selecting the pan type and material
•
Preparing the sample
•
Creating or choosing the test procedure and entering sample and instrument information through the TA
instrument control software
•
Setting the purge gas flow rate
•
Loading the sample and closing the cell lid
•
Starting the experiment.
To obtain accurate results, follow procedures carefully.
Before You Begin
Before you set up an experiment, ensure that the DSC and the controller have been installed properly. Make
sure you have:
•
Made all necessary cable connections from the DSC to the computer
•
Connected all gas lines
•
Powered up the unit
•
Connected any desired accessories
•
Connected the instrument with the controller
•
Become familiar with controller operations
•
Calibrated the DSC, if necessary.
Chapter 3
Use, Maintenance, & Diagnostics
