Use at the field
49
Start position
mode
The loading arm and the table must be put into start position before
wrapping can get started.
The start position is reached when:
•
the loading arm is in the middle position
•
the table is fully downwards and in the loading position
> Push to reset the table revolution counter
Wrapping
The wrapping cycle depends on the kind of control on the machine:
•
cable control
•
electronic control
Cable control
> Drive to the bale
> Move the right lever forwards to lift the bale using the loading arm
onto the table
> Move the right lever backwards to lower the loading arm complete-
ly
> Use the middle lever to start wrapping
The table must turn with maximum 30 rpm.
After the last but one number of film wraps, the buzzer sounds. Than
the final wrap is added.
Extra wraps can be added. The buzzer will sound 2 seconds for every
extra wrap.
> Leave the middle lever to stop wrapping
The bale counter will be reset to zero.
The table must be in tip off position now.
> Move the left lever backwards to unload the bale
> Move the left lever forwards to move the table into loading position
Middle lever
Right lever
Left lever
Summary of Contents for 7420
Page 5: ...Table of contents 5...
