Troubleshooting
89
Applicutter
Err 8
The magnet or the sensor for
the loading arm is defect or
wrongly positioned
> Adjust the magnet/sensor
so, that the sensor is activat-
ed when the loading arm is in
correct position
•
Err 9
The maximum time between
two pulses of the film end stop
sensor is exceeded
> Check if the film end stop
sensor works
> Increase t14
•
•
65
Err 99
The activated function is not
available for this machine
off
•
The control panel does not
communicate with the driver
module
•
Defect fuse at the main print
card in the driver module
> Check that the power supply
and the cables between con-
trol panel and driver module
are OK and properly con-
nected.
> Disconnect the power supply
for 15 sec and reconnect
> Check the fuse
Problem
Cause
Solution
Page
Problem
Cause
Solution
Page
The catch rod is not fully
charged
The applicutter is not adjusted
correctly
> Adjust the catch rod
The catch rod is not released
Basic setting of the applicutter
> Check that the distance be-
tween retainer and pawl is 10
- 20 mm
> Adjust correctly
The film is not cut
•
Too much pressure on the
roller
•
Roller does not rotate freely
•
The knife is dull
> Adjust the distance between
the roller and the retainer to
4 - 5 mm
> Oil the roller
> Exchange and adjust the
knife
Summary of Contents for 7420
Page 5: ...Table of contents 5...
