41
K
J
T
10.3 The control panel
The keyboard (K) is used for operating the
machine and to determine if fully automatic
or partly automatic operation. The various
key symbols are explained below.
The joystick (J) is used to select parame-
ters and to operate the selected joystick
functions.
The toggle switch (T) right has an approval
function (OK).
1. Start a programme sequence in Manual
mode, i.e. start the process from the current
programme step.
2. Stop wrapping before the pre-set number
of wraps is reached. The programme jumps
to the final step.
3. Zero setting of programme.
The toggle switch to the left has a clear/
delete function (C).
1. Clears (resets to zero) the error code in
the screen.
2. Sets the edited value back to the mini-
mum value available for the current parame-
ter.
10.3.1 Modus
Idle mode:
Bale processor in safe/stop situation. Light
at STOP key is on
The operator can from Idle mode access:
User functions
Editing user parame-
ters
Dealer functions
Editing dealer parame-
tres
Service functions Editing service par-
ametres
PIA mode
Sequential operations
of the hydr. functions
(emergency mode)
Tool mode
Manual operation by
using soft keys and
joystick. Sensors are
active in tool mode and
will prevent user er-
rors.
Operating model C
Process mode:
Is active when the light at STOP key is off.
Process mode is required for operation:
Automatic
(The whole wrapping
process runs automati-
cally after the operator
has activated the OK
switch.
Semi-automatic
(The operator must
confirm the next functi-
on
The operator can from Process mode ac-
cess:
PIA mode
See above
Tool mode
See above
Summary of Contents for 7640
Page 2: ...2 Operator s manual round bale wrapper 7640...
Page 13: ...13...
Page 39: ...39 Operating model S...
Page 71: ...71 Notes 13 Notes...
