64
Operator´s manual round bale wrapper 7640
10.11.3
Error/warning codes
The following table gives an explanation on the error codes:
If an error occurs the control panel will
activate an alarm signal for a few seconds.
The error code or restriction that caused the
alarm signal can then be read in the screen.
The error code in the screen can be cleared
at any time by operating the Clear switch.
The following screens are examples that
can show up:
The errormessages are stored for read out.
Screen 13 in Service menu.
Error
code
Symbol Description Comments
00
No error, OK state
02
Loading arm in sensor error
Timeout occurred on expecting loading
arm up position.
03
Loading arm out sensor error
Timeout occurred on expecting loading
arm down position.
04
Table position error
Zero position from sensor was expected.
05
Cutter down sensor error
Timeout occurred on expecting down
position.
06
Film break error
A film break situation was detected.
07
Low battery voltage warning
Battery power below preset warning value
08
Table sensor error
20+
General restriction error
A restriction error indicates a situation
where action is wanted but not allowed.
21
Satellite zero position restriction
Operation not allowed because satellite
has to be in zero position.
22
Load arm in restriction
Operation not allowed because loading
arm has to be in closed/inner position.
23
Load arm out restriction
Operation not allowed because loading
arm has to be in open/outer position.
24
Table position restriction
25
Film cutter position restriction
Operating model C
Summary of Contents for 7640
Page 2: ...2 Operator s manual round bale wrapper 7640...
Page 13: ...13...
Page 39: ...39 Operating model S...
Page 71: ...71 Notes 13 Notes...
