Chapter 2
CONFIGURING the INSTRUMENT
Installation
Overview
This chapter contains information and instructions necessary to
prepare the Model 9260 for operation. Details are provided for initial
inspection, grounding safety requirements, repackaging instructions
for storage or shipment, installation information and Ethernet address
configuration.
Unpacking and
Initial Inspection
Unpacking and handling of the generator requires normal precautions
and procedures applicable to handling of sensitive electronic
equipment. The contents of all shipping containers should be checked
for included accessories and certified against the packing slip to
determine that the shipment is complete.
Safety
Precautions
The following safety precautions should be observed before using
this product. Although some instruments and accessories would
normally be used with non-hazardous voltages, there are situations
where hazardous conditions may be present.
CAUTION
This product is intended for use by qualified persons
who recognize shock hazards and are familiar with the
safety precautions required to avoid possible injury.
Read the operating information carefully before using
the product.
Exercise extreme caution when a shock hazard is present. Lethal
voltage may be present on power cables, connector jacks, or test
fixtures. The American National Standard Institute (ANSI) states that a
shock hazard exists when voltage levels greater than 30V RMS,
42.4V peak or 60 VDC are present.