3
© 2017 TrackNet Inc, USA and Trackio GmbH, Switzerland. All rights reserved.
3.1 Ports
Wired Network
Indicates the state of the WAN and
LAN ports
Wi-Fi
Indicates the state of the Wi-Fi network
Tabs Network
Indicates the state of the Tabs network
Power
Indicates that the Hub is functioning
normally
Solid Green
Feature is operating correctly.
Solid Orange
Feature is not operating correctly.
The large, round button on top of your hub
enables Wi-Fi Protected Setup (WPS).
3.2 Icons
USB
The USB 2.1 Type A port can be used
for recharging Tabs devices.
WAN
This ethernet port is used to connect
your broadband Internet modem
provided by an ISP.
LAN
There are two ethernet ports for
adding other devices to your Local
Area Network.
Power
Connects to the supplied 12V power
supply
Reset Button
Pressing for six seconds resets the Hub.
3. Setup and Usage
The Hub may be installed into an existing WLAN network as a repeater or
create a new WLAN network while acting as a WiFi Access Point. In both
scenarios the Hub is configure via TrackNet’s Tab Application available for
both iOS and Android. As a WiFi Access Point an ethernet connection is
required to provide internet access. The two ethernet LAN ports provide
bridging into the network in Repeater or Access Point mode.
Once an internet connection is made available the Hub will establish con-
nections for both LoRaWAN traffic and management via the internet to
TrackNet’s TrackCentral services.
The four LEDs on the top of the Hub provide a easy to read summary of the
status of the Hub.
3.3 Status Lights
3.4 WPS Button
