TAC Xenta 555, Supplement Manual
11 VisiSat IP Tunnel Configuration
TAC AB, Oct 2006
71 (82)
04-00054-01-en
11
VisiSat IP Tunnel Configuration
VisiSat IP Tunnel configuration enables you to communicate with
MicroNet via Internet/Intranet, using the Xenta 555 as a web server.
With XBuilder and the VisiSat Configuration Tool installed on a single
PC, you can configure VisiSat objects at a remote site.
11.1
VisiSat Port Number
It is important to ensure that the correct port numbers are set up in
XBuilder and in the VisiSat server for successful communication to take
place. The port number is 7001 by default but there may be some sites
where this number has already been allocated and it will then be neces-
sary to use another number.
If you need to change the VisiSat port number in the MicroNet object’s
properties in XBuilder, in you will also need to change the port number
in VisiSat.
Refer to Chapter 4.1.2, “MicroNet Access (VisiSat Port)”, on page 27
to change the VisiSat port number in XBuilder.
Refer to
VisiSat Engineering Guide
(version 2.1 or later) to change the
VisiSat port number in VisiSat. However, for information purposes, the
method of changing the VisiSat port number is outlined here.
Summary of Contents for Xenta 555
