TAC Xenta 555, Supplement Manual
11 VisiSat IP Tunnel Configuration
TAC AB, Oct 2006
75 (82)
04-00054-01-en
11.2
IP Tunnel and Satchnet networks
By default the the Xenta 555 is configured to expect an NCP network in
the communications parameters for the imported network (refer to
Chapter 6, “Setting Up MicroNet Communications Parameters”, on
page 39):
However,
before
you can engineer a Satchnet network, you must first
set up a Satchnet project in XBuilder in order to ensure successful IP
Tunnel communications with the Xenta 555 (refer to Chapter 5, “Creat-
ing a MicroNet Network in TAC XBuilder”, on page 33).
A completed XBuilder project is not required at this stage, only the
establishment of a Satchnet network. This is achieved by the selection
of a
Satchnet SNP
network in the drop-down box of the
Network Type
parameter:
You must also set the
Baud Rate
parameter to match the speed of your
Satchnet network (either 1200 or 4800 bauds).
Summary of Contents for Xenta 555
