j.
k.
l.
m.
n.
o.
p.
Battery Safety
WARNING
Li-Ion batteries, if incorrectly used, stored or charged are a fire, burn and
explosion hazard.
●
●
●
●
●
●
●
●
Battery Charger Safety
Use the battery charger correctly
●
●
- 08 -
Drill bits get hot during operation, allow to cool prior to handling them.
NEVER use your hands to remove sawdust, chips or waste close by the bit.
lIf you are interrupted when operating the drill, complete the process and switch
off before looking up.
Where possible, use clamps or a vice to hold your work.
Examine the chuck regularly for signs of wear or damage. Have damaged parts
repaired by a qualified service centrer) ALWAYS wait until the drill has com.
ALWAYS wait until the drill has come to a complete stop before putting it down.
Periodically check all nuts, bolts and other fixings and tighten where necessary.
Keep the battery out of reach of children.
ONLY charge Li-Ion batteries using the charger provided or designed specifically
for your product.
ONLY use Li-Ion batteries provided with a product or specifically designed to be
compatible.
Allow batteries to cool for 15 minutes after charging or heavy use. Failure to follow
these instructions may cause overheating or fire
When not in use batteries should be stored at room temperature (approximately 20°C).
Ensure that battery contacts cannot accidentally short in storage. Keep batteries
clean; foreign objects or dirt may cause a short. Keep away from other metal
objects, for example, paperclips, coins, keys, nails and screws.
Under abusive conditions, liquid may be ejected from the battery. This liquid may
cause skin irritation or burns. Avoid contact. If contact accidentally occurs, flush
with water. If liquid contacts eyes, seek medical help.
DO NOT open, disassemble, crush, heat above 60°C or incinerate. Do not
dispose of in fire or similar.
Refer to the section of this manual relating to use of the battery charger before
attempting to charge the battery.
Do not attempt to use the charger with any batteries other than those supplied.
Keep your battery charger clean; foreign objects or dirt may cause a short or block
