► Do not submerse power unit.
► Use drop cloths during pouring, mixing, and viscosity testing of materials to be sprayed to
protect your floors and anything else in the spraying area that you wish to remain untouched.
To begin cleaning:
► Turn the power unit off, unplug the cord and disconnect air hose from sprayer.
► Unscrew the canister from the sprayer and pour any remaining liquid back into the original
container(Fig. M).
► Pour a small amount of the appropriate cleaning solution into the canister (Fig. N).
- Warm soapy water for water based materials
- Manufacturers recommended cleaning solution for oil based materials
► Screw on the canister back to the sprayer securely and vigorously shake the sprayer.
► Unscrew the canister and properly dispose of cleaning solution.
► Refill the canister with a small amount of new cleaning solution (Fig. M). Screw on the
canister back the sprayer.
► Reattach the air hose to the sprayer, plug in the cord and turn on the power unit.
► Spray the cleaning solution through the sprayer onto scrap material for 2 to 3 seconds
(Fig. O).
► Turn the power unit off, unplug the cord and disconnect air hose from sprayer.
► Unscrew the canister from the sprayer.
► Remove the o-ring(#14), pickup tube(#15),check valve (#16), and quick refill lid(#12) from
the sprayer. Clean the parts with the cleaning brush in the appropriate cleaning solution (Fig.
P).
Note:
When removing the check valve, twist the check valve clockwise and then pull it
out.(Fig. P)
► Unscrew the tip collar (#4) and remove all the parts of the spray nozzle(#3, #4, #5, #6, #7.
#8) from the sprayer. Remove the spray tip(#9) from the sprayer ( Fig.Q1). Clean all parts
with the cleaning brush in the appropriate cleaning solution (Fig. Q, Fig.Q1). Be sure to clean
around check valve with brush (Fig. Q).
► If using water based material, clean the sprayer by running water through pickup tube inlet
as shown in (Fig. R). If using oil based materials, clean pickuptu be inlet with the appropriate
cleaning solution. Repeat until sprayer is completely clean.
► Dry all parts thoroughly.
► Properly dispose of cleaning solution.
► Place a drop of household oil into the inside of the sprayer, convenient to assemble the
spray tip(Fig. S).
► Reassemble sprayer (Fig. T).
Note:
Spray nozzle can only be assembled in one direction that the notch of the nozzle(#6)
must align with the skirt on spray unit housing(#10). Refer to (Fig. T1) for proper assembly
Note:
The spray tip must be assembled in the sprayer with the bumps on the spray tip in
vertical direction
- 19 -
Summary of Contents for SGP17AC
