17.
18.
19.
20.
21.
22.
23.
24.
25.
26.
27.
28.
29.
Please ensure that the blue end of the smart jump clamps is fully
inserted into the product 12V car start port when you use it to
start your car, otherwise the blue end may melt.
Please use the jump clamps which comes with the device only.
When the battery clip or wire is damaged, please stop using it to
avoid personal injury such as fire and electric shock.
Do not use the clamps to power other equipment.
Before starting, make sure there is no rust and foreign matter at
the interface, and tightly connect the device with the jump clamps.
Non-tight connection will affect the starting performance of the
device.
Do not use the device to start the car while it is being charging.
Do not use the device to continuously start the car more than 3
times.It may cause the product to overheat and damage the
product. Each starting should be separated by two minutes.
After successfully starting, please remove the product from the
car battery within 30s, otherwise it may cause damage.
Do not charge the device immediately after use it to start the car
successfully.
Please charge it in the environment temperature between 0
℃
~45
℃
.
Please use the comes with wall charger or the same specification
charger to charge the device.
In extreme cases, the battery may leak. Do not touch the liquid
directly with your hands or skin. If you accidentally touch it, rinse
it off immediately with soap and water. If you accidentally get into
your eyes, rinse your eyes with cold water for at least 10 minutes
and seek medical attention immediately.
If the product battery leaks, please recycle it with the appropriate
equipment immediately.
Lithium battery based products should be disposed according to
local regulationsat at the end of the product's life.
- 10 -
