Taco Comfort Solutions 0018e-SF4, Instruction Sheet

-10-

This equipment has been tested and found to comply with the 

limits for a Class B digital device, pursuant to part 15 of the FCC 

Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This  

equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio commu-

nications. However, there is no guarantee that interference will 

not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can 

be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of 

the following measures: 

Reorient or relocate the receiving antenna. 
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from 

that to which the receiver is connected. 
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada license exempt RSS 

standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and 
(2) This device must accept any interference, including interfer-

ence that may cause undesired operation of the device. 
Le présent appareil est conforme aux CNR d’Industrie Canada 

applicables aux appareils radio exempts de licence. L’exploitation 

est autorisée aux deux conditions suivantes: 

(1) l’appareil ne doit pas produire de brouillage, et 
(2) l’utilisateur de l’appareil doit accepter tout brouillage  

radioélectrique subi, même si le brouillage est susceptible  

d’en compromettre le fonctionnement. 
Under Industry Canada regulations, this radio transmitter may 

only operate using an antenna of a type and maximum (or lesser) 

gain approved for the transmitter by Industry Canada. To reduce 

potential radio interference to other users, the antenna type and 

its gain should be so chosen that the equivalent isotropically  

radiated power (e.i.r.p.) is not more than that necessary for  

successful communication. 
Conformément à la réglementation d’Industrie Canada, le  

présent émetteur radio peut fonctionner avec une antenne  

d’un type et d’un gain maximal (ou inférieur) approuvé pour 

l’émetteur par Industrie Canada. Dans le but de réduire les risques 

de brouillage radioélectrique à l’intention des autres utilisateurs, il 

faut choisir le type d’antenne et son gain de sorte que la puissance 

isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité 

nécessaire à l’établisse-ment d’une communication satisfaisante.
To comply with FCC and Industry Canada RF radiation exposure 

limits for general population, the antenna(s) used for this trans-

mitter must be installed such that a minimum separation distance 

of 20cm is maintained between the radiator (antenna) and all 

persons at all times and must not be co-located or operating in 

conjunction with any other antenna or transmitter.

CAUTION