-5-
NEUTRAL
LINE
WIRING DIAGRAM
Removable
Green
Terminal
Plug
Terminal
Screws
GROUND
G
N
L
4. Wiring the circulator:
Disconnect AC power supply. Remove terminal box cover. Attach a wiring connector
into knockout hole. Use flexible conduit only. The green terminal plug may be removed to simplify wiring, then
snapped back in place. Connect Line/Hot power to the L terminal, Neutral to the N terminal and Ground to the
G terminal. See wiring diagram above. The 0026e is a double insulated circulator; grounding wire is not necessary but
recommended for safety. Replace terminal box cover. Insert rubber cap plug provided to cover unused knockout hole.
4a. Wiring the circulator for 0-10V DC Operation:
(See Page 9)
5. Start the circulator:
When purging the system, it is recommended to run the circulator at full speed long
enough to remove all remaining air from the bearing chamber. This is especially important when installing
the circulator in the off-season. Turn the dial to the HIGH setting for maximum fixed speed. A blue LED will
illuminate when the 0026e is powered on.
CAUTION: Never run the circulator dry or permanent damage may result.
ATTENTION: Ne laissez jamais le circulateur tourner à sec, des dommages permanents peuvent en résulter.
Full Speed Operation:
To run the pump at full speed during the fast fill, start-up and purge process, rotate dial to HIGH setting. The LED will
change to blue. To return to the normal operating mode, turn dial to desired activeADAPT, LOW, MEDIUM, HIGH or
0-10V setting.
Wiring Diagram
