14 |
www.BabyLock.com
Installation and Setup
Carriage
You should have your frame set up and ready to go. Refer to the frame manual for detailed instructions
about setting up the frame.
To install the carriage and machine on the frame (with machine turned off and unplugged)
1. Place the carriage on the tracks, ensuring that
the stitch regulator faces the back of the frame.
2. Place the machine on the carriage.
U
CAUTION
: It is suggested to have two
people when lifting the Gallant. Always lift
from the throat of the machine, not from
the handlebars, needle bar area or
needle bar.
3.
At the back of the machine, plug the carriage
encoder cable into the round jack on the back
of the machine (to the left of the power cord).
Plug the other end into the encoder.
4. Secure the carriage encoder cable through the
clip at the back of the machine. Check that
there is no strain on the cable at the plug into
the machine.
5. Plug the
machine
encoder cable into
the round jack on the right side of the machine
(as seen from the rear of the machine). Plug the
other end into the encoder.
Â
IMPORTANT: If you ever need to remove
the machine from the carriage, disconnect
the carriage encoder cable from the carriage
encoder. Failure to unplug the cable when
removing the machine from the carriage
could result in damage to the cable or
carriage encoder.
U
CAUTION:
Never plug or unplug the encoder
cables or any other cables while the quilting
machine is on, as this could potentially
cause electrical damage to the machine
or encoders.
