Gallant User Manual
| 15
Power Cord
To install the power cord
•
Insert the plug into the power connector on the rear of the machine. Plug the three-prong plug end
into your power source.
Do not turn on the machine until the handlebars are installed.
To disconnect the power cord
•
First pull out on the red buttons on the sides of the
plug and then pull the plug out of the machine.
NOTE: Make sure that the machine is off before
plugging into a power source. The main power
switch should be in the O (off) position.
Front Handlebars
T
he Gallant comes with handlebars for the front of the machine. Optional rear handlebars are available
for quilting with pantographs and Groovy or pattern boards. The front handlebars are used for most other
quilting activities.
U
CAUTION: To prevent any electrical damage to the handlebars, always turn off all power to the
machine when connecting or disconnecting the handlebars.
To install the front handlebars
1. Remove the two screws in the front top
cover with a 3mm hex tool. Remove
cover by pulling up on the rear portion
then sliding tabs out in the front.
2. Place four M4x10mm screws with
washers down through the handlebar
into the top of the machine and tighten
them firmly with a 3mm hex tool.
3. Plug the two handlebar cable plugs into
the two jacks in the back top (left plug
to left jack and right to right). The right
handlebar cable is labeled.
4. Push ferrites down into the space so
that the cover will fit back into place.
5. Replace the front top cover by sliding
tabs at the front into machine and
angling the rear of the cover down into
place. Tighten the screws with a 3mm
hex tool. Do not over tighten.