Gallant User Manual
| 17
O
ptional Accessories
Please visit www.babylock.com to view additional optional accessories not featured in this guide.
R
ear Handlebars and Laser
To install the rear handlebar
NOTE: Make sure that the machine is off
before installing the rear handlebar. The
main power switch must be in the O (off)
position.
1. Slightly loosen the two Philips screws on the
rear handlebar connection cover with a #1
Phillips screwdriver (not provided). Do NOT
remove the screws.
2.
Pull off the plastic cover. It protects the
rear handlebar connection. Do NOT
remove the screws.
3.
Re-tighten the two screws. They hold
the connection board to the machine.
4. You will need three M5 x 12 SKB ZN screws for
the rear handlebars and the 3mm hex wrench.
5.
Align the three holes in the handlebars with
the holes on the back of the machine.
6.
Attach with the three screws. Tighten securely.
To install the laser pin
1. You will need the laser pin, washer and nut.
2. Screw the nut all the way onto the laser pin.
3. Slide the washer onto the laser pin threads and
screw the laser pin all the way into the side of
the machine.
4. While holding the laser pin firmly, tighten the
nut with the 8mm wrench (provided).
