Tactacam 6.0, Instruction Manual

15

HELPFUL TIPS

warm tap water for 5 minutes and then rinse thoroughly to remove the debris 

before opening.

• The camera is water-resistant; no housing needed. Ensure that the back cap is 

closed and locked before using the camera around water, dirt, or sand.

• For best audio performance, ensure the microphone hole is free of water or 

debris. To remove obstructions, shake the camera or blow on the mic to remove 

water and debris from the microphone hole. 

*DO NOT

stick anything in the mic hole as you could damage the mic.

IMPORTANT MESSAGES / CAMERA VIBRATIONS

If the camera begins to vibrate for 5 seconds on and 5 seconds off repeatedly, check 

the following:

NO SD card 

= The camera requires a microSD, microSDHC or microSDXC card to 

capture videos.

SD FULL

 = Delete files or swap card.

SD ERROR

 = Camera is unable to read card. Please format the card and try again. 

NOTICE: 

When formatting SD cards, if you select Yes, all of your card’s content 

WILL BE DELETED

. To avoid loss of video, download all files onto your computer in a 

separate file. Reformat your microSD card on a regular basis to ensure that the card 

can continue to receive information from the camera.

CAMERA BATTERY

Your camera and battery need to stay connected when operating.  

DO NOT

 remove the battery from the camera when in use or your data will be lost.

On your Tactacam 5.0 there are 4 Green LED battery indicator lights. When all 4 lights 

are illuminated the camera battery is full. As the battery levels decreases the lights 

will begin to reduce in numbers till there is one LED light remaining. The last battery 

level LED indicator light will begin to blink when the battery drops below 10%. If the 

battery reaches 0% while recording, the camera saves the file and powers off.