Tactic TTX600, Instruction Manual

9

environments which might not be recommended. Additional Tactic TR624 receivers 
can be purchased from your local retailer (part number TACL0624) to work with this 
TTX600 transmitter.

SERVOS

Center the trims on the Tx. Mount the servos inside the model, and connect the 
linkages to the servo using an appropriate length servo arm.

All servos should be mounted 
as shown in the model’s 
instructions. Use rubber 
grommets, screws and brass 
eyelets supplied (where 
applicable) when mounting 
your servos (see above). 
Do NOT over-tighten the 

mounting screws, as the servos should be able to move slightly to compensate for 
engine vibration. Use a servo horn long enough to accommodate the entire range 
of movement for that particular control. When mounting the servos, make sure 
the pushrods are not too loose or bind in any way. Pushrods should be capable 
of operating the full range of the servo. This can be tested by moving the Tx sticks 
to maximum positions several times while observing the movement of the control 
services. If a servo is binding or sticks in fl ight, it should be re-adjusted so as not to 
drain excessive current from the battery and thus shorten fl ight time.

Rudder

Servo

(Ch4)

Flap

Servo

(Ch6)

Retract

Servo

(Ch5)

Receiver

Throttle

Servo or

ESC (Ch3)

Elevator

Servo

(Ch2)

Aileron

Servo

(Ch1)

Switch Harness

To Rx Battery

To Charger

6-CHANNEL RECEIVER

Connect the servos to the Rx as shown. Route the wires so they do not interfere 
with any moving parts. Move the Tx trims to fi nely adjust the servo’s center point as 
needed to match the installation. See the 

SERVOS AND ACCESSORIES

 section on 

page 17 for a full list of optional servos.

Rubber Grommet

Brass Eyelet

Servo

Servo

Servo

Screw

Servo Tray