Tactic TTX850 Quick Start Manual Download

Page: 4 / 4

3. Using hemostats or needle-nose pliers, grasp one loop end of the spring

and hook the opposite loop end of the spring onto the arm down inside
the gimbal.

4. Pull the spring upward and securely hook the top loop end onto the spring

tension lever, and release.

5. Adjust the spring tension screw until the desired tension exists for the

vertical movement of this stick.

Case Assembly

1. Carefully tuck all cables back inside as when the case was opened.

2. Align the case rear back onto the case front,

making sure that no wires are pinched between the case parts.

Press

the case halves together.

3. Insert the six screws back into their positions and carefully tighten until snug. Do not cross the threads or over-tighten

the screws.

4. Re-connect the battery inside the battery compartment and close the battery door. Test all mechanical and electronic

changes for proper operation.

Mode change is complete. If you have questions, contact Hobby Services as follows:

HOBBY SERVICES

3002 N. Apollo Drive, Suite 1

Champaign, IL 61822

Tel: (217) 3980-3630 (9:00am – 5:00pm CST, M-F)

E-mail: hobbyservices@hobbico.com

Summary of Contents for TTX850

Page 1: ...utton can be released 4 Press the button to move the cursor next to the STICK MODE selection 5 Press ENTER then the button to change the selection to MODE1 Press ENTER again 6 Press ESC to exit the Sy...

Page 2: ...e inside of the radio Throttle Ratchet Bar 1 A long metal bar will be installed vertically across the rear of one gimbal This bar provides resistance and a ratchet feel for the throttle control Note t...

Page 3: ...by gently lifting the assembly straight upwards and set aside Elevator Arm and Spring Installation The plastic arm and spring must be installed onto the opposite gimbal which doesn t have the metal t...

Page 4: ...ar back onto the case front making sure that no wires are pinched between the case parts Press the case halves together 3 Insert the six screws back into their positions and carefully tighten until sn...