Tactical Electronics Sire, Operation Manual

The SIRE is powered by an internal rechargable 11.1V Lithium Polymer battery.  The SIRE Hand Controller is powered by 
two 1.5-Volt Alkaline (AA) batteries.

The diagrams on the following pages demonstrate proper battery installation and power-up for the SIRE and SIRE Controller.

»

SIRE Battery:

The SIRE is powered by an internal rechargable 11.1V Lithium 
Polymer battery.

»

SIRE Power-Up Procedure:

The power switch for the SIRE is a push button located on 
the inside face of the unit (located to the left of the battery 
charging port).  Fully depress the power switch to power the unit 
ON.  Depress to power the unit OFF.

Once the SIRE is powered ON, the Link LED will flash rapidly, 
indicating the SIRE is ready to be paired to the Hand Controller.

»

Hand Controller Battery Compartment:

The SIRE Hand Controller is powered by two 1.5-Volt Alkaline 
(AA) batteries. To insert the batteries remove the back panel 
of the unit and insert the batteries taking note of proper 
orientation. 

The image on the left depicts the proper orientation for the 
batteries. In addition, the battery holder indicates the proper 
orientation as well.

Always remove batteries when unit is not in use.

»

Hand Contoller Power-Up Procedure:

To power on the SIRE Hand Controller press the power button 
located at the bottom of the unit. When the contoller is powered 
ON, the status LED initially lights red. Once the status LED 
lights green, the unit is fully operational.

To power OFF the Hand Controller, press and hold the power 
button for 2 seconds and then release.

NOTE: When the battery becomes low, the status LED will 
change from green to red and stay red.

OPERATION AND SUPPORT PUBLICATION

SIRE POWER UP

6

Tactical Electronics & Military Supply

POWER