MICO-PS-3P
20
Wizard
Wizard is a configuration program that can assist you in setting up the necessary parameters
for your print server device to function. Setup a print server by using Wizard.
TCP/IP Wizard
1.
Click
Wizard
button just like a picture
.and select
TCP/IP Wizard
.
2 Select
“
Obtain an IP address from DHCP server
”. If there is a DHCP server on your
network. This option allows the print server to obtain IP-related settings automatically
from your DHCP server. This setting, by default, is disabled. If you would like to manually
specify an IP address to the device, please skip to the following step.
3 In
the
IP Address
option, type an IP address for the print server. The IP address must
meet the IP addressing requirements of the network segment.
MICO-PS-3P
21
4
(Optional)
In the
Subnet Mask
option, type the Subnet Mask your LAN or network
segment is currently configured to use.
5
(Optional)
In the
Gateway
field, type the IP address of gateway.
6 When
done,
click
OK
button. The program will save the above settings into the print
server.
7 Done
NetWare Wizard
1. Log into your NetWare file server as a Supervisor (Admin.) or equivalent.
2. Click
Wizard
button just like a picture
.and select
NetWare Wizard
, as follow
picture.
3. Select the NetWare File Server to which the print server device will be attached.
4. Type in a Print server.
5. Type in a Print Queue Names.
Note:
Each print queue corresponds to each print port of the print server.
6. Click
OK
.
7. Done.
8. From your NetWare client computer, such as Windows 95/98/Me, create a printer that is
connected (redirected) to one of the NetWare print queues serviced by the print server.