MICO-PS-3P
24
Upgrade
Upgrade allows the user to upgrade the print server device. In order to upgrade the unit
please perform the steps as follows:
1. Click
Upgrade
button just like a picture
, as shown as follow picture
2. Select
General Upgrade
. Make sure that the upgrade file is located in the same
directory as PSAdmin.
Reset
1. Click
Reset
button just like a picture
.
2. Reset allows the user to reset the print server device in order to establish a new
connection or for new settings to take effect.
Refresh
1. Click
Reset
button just like a picture
.
2. Refresh searches the network for all attached print server(s).
Note
: Configure the print speed in the
Advanced
label, must match the printer’s speed
which connect to the print server. Undependable configuration will cause printer to
abnormal printing.
MICO-PS-3P
25
Multiple Print Queues Configuration
To configure the print server to service multiple print queues, please follow the instructions
listed below:
1. Log into your NetWare file server as a Supervisor (Admin.) or equivalent.
2. Run
the
PSAdmin
from your Windows.
3. Select the print server and to be configured.
4. Click
the
Wizard
icon in the tool bar.
5. Type in a Print server and a Print Queue Name (For more detailed information about
Wizard
, please refer to the “
Wizard
” section in this chapter).
6. Run the NetWare’s PCONSOLE and create additional print queues.
7. Select the Print server name you specify in Step 5.
8. Select
the
“
Print server Configuration
” option and select the ”
Queue Serviced by
Printer
” option
(For NetWare 4.x’s PCONSOLE, please select “Printers” option and
select “Printer 0” instead)
.
9. Select the “
Printer 0
” and press the [
Insert
] key to add the print queues you create in
Step 6 into the list
(For NetWare 4.x’s PCONSOLE, please select “Print queues
assigned” option instead)
.
10. Reset the print server by clicking the “
Reset
” icon from the PSAdmin. Done.
Note:
Please refer to NetWare’s Print server/Services manuals for detailed PCONSOLE
commands.
Uninstalling the PSAdmin on Windows PC
To help users easily remove all installed software components of the PSAdmin from their
Windows PC, and the PSAdmin software comes with un-installation wizard program that can
automatically remove the software components from their Windows PC systems in minutes.
Please follow the directions listed below to proceed with the un-installation procedure.
After the PSAdmin is removed, the print server is no longer accessible via the PSAdmin. You
have to re-install the PSAdmin on your system in order to access the print server again.
Procedure:
1. Click
Start
, point to
Settings
, and select
Control Panel
.
2. Double
click
the
Add/Remove Programs
icon.
3. Click
Change or Remove Programs
tab.
4. Select
Network Print Monitor for Windows 95/98/NT/2000/XP/2003
and click
Change/Remove
button.
5. The un-installation wizard program will be launched.
6. Follow the directions on the screen to complete the un-installation procedure.
