T G W S IP -F X S /F S O G a te w a y S e rie s
User Manual
Tadiran Telecom
51
Name
Description
Note:
The following features are valid only in SIP protocol. When the gateways use MGCP protocol, the control of all call
services is provided by the proxy server without the need of these setting.
Inbound handle
The gateways provide three scenarios for handling incoming calls on the FXO trunk:
Binding:
when a telephone call reaches the FXO port, the gateways will route the call to a
FXS port according to the DID number bound with the port.
Note: Setting a number to be bound is required or this setting is invalid.
Second-stage dialing
: when a telephone call reaches the trunk port, the gateways will provide
the second dial tone and route the call according to the extension number entered. Dialing tone
or voice prompt file can be changed by user.
Direct
: the gateways will route the incoming call on FXO port n to the corresponding FXS
port n. For example, a call made to the first FXO port is forwarded to the first FXS port.
Note:
Direct
applies only to a device having both FXO and FXS ports.
Voice prompt
Play the second dial prompt uploaded on
Advanced
>
Greeting file
page
Dialing tone
Play the second dial tone configured on
Advanced
>
Tones
page.
RFC6913
If this item is selected, the Fax over IP label carried in INVITE is supported.
TLS
If this option is enabled, the TLS server configured on
Basic
>
SIP
page is used for both
registration and calls over this line.
If this option is not enabled, the default registration server and proxy server are used.
SRTP
Enable SRTP.
Registration
subscription
Periodically send subscription messages to the SIP server. The period of sending the subscription
messages is the same as the
Registration expiration
in
Basic
>
SIP
.
Note: This parameter is displayed only when
IMS
is selected and
Registration subscription
is
checked on
Advanced
>
SIP
page.
Polarity reversal
signal detection
If a PSTN line supports reverse polarity, make the selection here. Or this setting is invalid. By
default, this is not selected.
Caller ID detection
Select to enable the detection function of caller ID for this FXO port. By default, this is not
selected.
Outgoing call
barring
Select if this FXO port bars outgoing call service to the PSTN. By default, this is not selected.
Echo cancellation
Select if echo cancellation is enabled for this FXO (Line).By default, this is selected.
Connect signal
delay
After making an outgoing call from a FXO port, the gateway will send a 200 OK message to the
platform with a delay if this parameter is selected. If unselected, the system sends a 200 OK
message to the platform after off hook on the FXO port. Also see
Answer delay
on page
Trunk
>
Advanced
.
Recording
Select if recording service is activated. This is not selected by default.
2.4.3 Trunk Batch (Unavailable on the TGW4)
Only a gateway with FXO ports can display this interface.
After login, click
Trunk
>
Batch
to open the configuration interface.
Step 1
Click
, the following interface is shown. Choose batch configured trunks and click
OK
.
Step 2
Click
to activate this function to configure this parameter. For details of the parameter, see
Trunk > Feature
.
Summary of Contents for aeonix TGW4
Page 15: ...Tadiran Telecom xv...
Page 16: ......
Page 133: ...T G W S IP F X S F S O G a te w a y S e rie s User Manual Tadiran Telecom 117...