8-88
Common Control Cards
Coral FlexiCom 6000 Installation Manual
CL
A-A
T
S Cor
a
L
INK
®
Adapter Car
d
8
If applicable, the Coral system is shipped to the customer with the CLA-ATS card(s)
installed in the control shelf slot(s). However, there are instances where a card is
removed and/or replaced. After installing the CLA card, perform the following:
Before inserting the CLA-ATS card:
1.
Place the card on the anti-static sheet.
2.
Verify that the W4 jumper is connected using a strap placed on top of the
jumper (see W4 jumper position located on
).
3.
If not already inserted, insert the appropriate CLA compact flash memory disk
(CFD) into the drive on the CLA-ATS card side (see
).
For information on how to insert and remove a CLA card from the cage, see
and Removing a Control Card, page 8-9
.
During system initialization, while the PI registers the display messages for a properly
Messages for a Properly Loading Active Side, page 3-12
Messages for a Properly Loading Standby Side
) the following message should be
displayed among the startup messages, indicating that the CLA-ATS has initialized
properly:
CLA is Active
.
Refer to Chapter 27 of the relevant
Program Interface & Database Reference Manual
for other CLA-ATS messages indicating a faulty CLA initialization along with
technical recommendations.
...................................................................................................
3
Inserting the CLA-ATS Card
Do not modify the jumper straps. All of the jumper straps are inserted by the
manufacturer. Modifying the jumper straps might damage the card.
