Attendant Features
225
T207M, T208M, T207M/NP, T208M/BL User Guide
Station Setup Features
boss group, keyset voice page, zone group page, page public address, UNA/central bell, outside trunk call,
public and private speed dial, pre-recorded DVMS message, group call, and network number
.
NOTE!
Hot Station Delay is not applicable for SIP telephones, such as: T207S, T208S, T207S/NP, and
T208S/BL.
[HotI]
Hot Station Immediate
is used to program a telephone to immediately ring another station, automatically
connect to a paging device, or automatically dial out
immediately when the handset is taken off-hook, or
SPKR
is pressed (or upon dialing from T207S, T208S, T207S/NP, and T208S/BL telephones)
. Possible
destinations are
operator, station, hunt group, boss group, keyset voice page, zone group page, page public
address, UNA/central bell, outside trunk call, public and private speed dial, pre-recorded DVMS message,
group call, and network number
.
♦
[OrgO]
Originating Only
is used to prohibit incoming calls from arriving at a station. In this case the user can only
make outgoing calls, but is unable to receive calls. A caller to this station will hear the reorder tone.
♦
[noTK]
Outgoing Call Restriction
is used to prevent a station from making outgoing trunk calls.
♦
[Blck]
Station Blocking
is used to temporarily prevent a station from both making and receiving calls. A caller to
this station will hear the reorder tone.
♦
[TrmO]
Terminating Only
is used to prohibit a station from originating any telephone calls (internal or external).
When defined as Terminating Only, the user can receive calls, but is unable to make calls.
