Station Telephony Features
124
T207M, T208M, T207M/NP, T208M/BL User Guide
Group Calls: Adding Participants (by Group Operator)
Group Calls: Adding Participants (by Group Operator)
Allows the group operator to add participants to an established conference of which the group operator is also a participant.
Adding an additional participant to an ongoing Group Call:
1. Press the preprogrammed
ADD MEMBER
DSS key during an established conference; the corresponding DSS key is lit.
NOTE!
See
for instructions on how to program a DSS key. To program an ADD MEMBER key,
use feature code #1304.
2. Press the member’s preprogrammed DSS key.
NOTES!
• You cannot manually dial the internal/public/private library number. Therefore, you will need to assign DSS keys
for each conference member (up to 6 or 15, depending on system hardware) you want to be able to add to a
Group Call following this procedure.
• DSS buttons may also be programmed with Trunk Groups followed by an external dial number to enable joining
external members. These members, however, are subject to all previous group call definitions, where they must
be given the right to speak or remain in Mute mode while listening to the Group Call (see
).
3. The member’s phone rings.
The ADD MEMBER DSS key LED is turned off and the member’s DSS key lights at the Group Operator’s station.
4. The member answers and joins the group call.
NOTE!
The ADD MEMBER DSS LED remains lit when attempting to add a non-legal dial number to the
Group Call, allowing you to attempt another number.
