Standby Mode (Sby):
helpful when changing a filter or a Jetpak. Press TEMP followed by JET 2
rn
high speeds
f a two pump system). If left running, the pump will turn off automatically after
ote: An optional auxiliary control button can activate either pump.
ca
to turn on light. Press LIGHT again to shift through color options. The light will turn off
utomatically after 4 hours.
reset Filter Cycles
JETS 1. Press TEMP to select the filter duration. Press JETS 1 to select the number
ring filtration. At the start of each cycle, the blower will run on
or 5
r 1-12 hours. The default filter time is 2 hours.
Protection
ycle (optional)
*Ozone
The ozo
during c
or AUX to start mode, to exit this mode press any button.
Sleep Mode (SLP):
heats the hot tub to within 20
°
F (11
°
C) of the set temperature during filter
cycles only.
Jets 1
Press JETS 1 to turn pump 1 on or off and to shift between low and high speeds. The low speed will tu
off after 2 hours and the high speed will turn off after 15 minutes.
Low speed of pump 1 may activate for at least 2 minutes every 30 minutes to detect the hot tub
temperature (polling) and will heat to set temperature if needed. When the low speed turns on
automatically, it cannot be turned off from the control panel.
Jets 2
Press JETS 2 to turn pump 2 on or off and to shift between low and
(i
15 minutes.
N
Light
Press LIGHT to turn the light on or off. The light will turn off automati
LED Light
Press LIGHT
lly after 4 hours.
a
P
Press TEMP then
of filter cycles. The display will show
dn
(day and night),
d
(day only), or
n
(night only). Press TEMP to
adjust. Press JETS 1 to exit the program.
The pump and ozone generator* will run du
highest speed for 30 seconds to clean out the air channels. The lowest speed of pump 2 will run f
minutes. The first filter cycle begins 6 minutes after the hot tub is powered up. The second filter cycle
begins 12 hours later. Filter duration is programmable fo
Freeze
If the temperature drops to 44
°
F (6.7
°
C) within the heater, the pump automatically activates to provide
freeze protection. The pump will stay on 4 minutes after the sensor has detected the temperature has
reach 45
°
F (7.2
°
C) or higher.
Clean-Up c
A clean-up cycle begins 30 minutes after the pump is turned off or times out. The pump and ozone
generator* will run for 1 hour.
Generator (optional)
ne generator runs during filter cycles (except when pump 1 is operating on high speed) and
lean-up cycles.
Tadpole Hot Tub Owner’s Manual
12
