Hot tub light does not work:
Solution:
Replace light bulb.
Cause #2:
Lighting system is defective.
ed Tadpole Hot Tub dealer.
ot tub pump will not turn on, creates a burning smell while running, or makes excessive noise
Cause #1:
Light bulb has burned out.
Solution:
Contact your authoriz
H
while running:
Cause:
Pump motor is defective.
Solution:
Contact your authorized Tadpole Hot Tub dealer.
ets surge on and off:
J
Solution:
Adjust water to the water level indication on the faceplate of the filter assembly.
ets are weaker than normal or do not work at all, but the pump is running:
Cause:
Water level is too low.
J
sed.
Solution:
Open jet handle(s).
Solution:
See “Cleaning the Filter”.
Cause #3:
There is air trapped in the hot tub equipment or its face piping.
air to bleed out of the system.
ch air bleed valve as soon as water starts to flow.
cking the suction fitting(s).
alled (if applicable).
Note: Running the hot tub without a JetZone, divider can cause serious damage to the pumps.
Cause
#6:
Slice valve is closed.
Cause #1:
Jet handle(s) are partially or fully clo
Cause #2:
Filter cartridge is dirty.
Solution:
Open the air bleed valve on each pumps housing and allow
Be sure to tighten ea
Cause #4:
The suction fitting(s) are blocked.
Solution:
Remove any debris that may be blo
Cause #5:
The JetZone divider is not inst
Solution:
Re-install in the appropriate JetPak.
Solution:
Open valve and secure with valve keeper.
Tadpole Hot Tub Owner’s Manual
27