TAGHeuer Timing
Page 8 / 20
2.5. Count Down mode (CD)
This mode allows you to make a unit count down or loop count-down
1. Number of split / Memory status
2. Running status
3. Counter
4. Count Down (max 59:59.9)
2.5.1
Set Count Down
To change the Count-Down value, the memory has to be deleted.
To set the Count-Down value:
-
Press the
MEMORY
button: the first digit will flash and
SET
icon is ON
-
Press the
SPLIT/LAP
button to change the value
-
Press again the
MEMORY
button to change to the next digit
-
Validate your setting with the
MODE
button (
SET
icon is OFF)
2.5.1. Count Down timing .
-
To start the count down, press
START/STOP
button (
icon is OFF)
-
The count-down value decrements (on the bottom)
-
A timer (on the top) is started (increments)
At any time it is possible to
PAUSE
and
RESTART
the count-down
A long single beep will sound at the end of the Count-Down
The count-down will stop automatically at 00:00.
To restart a new count-down, you have to reset the value by pressing
SPLIT/LAP
button.
During the count-down sequence, by pressing the
MODE
button, it is possible to
change the Single Count-Down to Auto-Restart Count-down (loop mode).
The
CD
icon on the LCD will switch.
In this Auto-Restart Count-Down, during the last 5 seconds, the Pocket Pro will sound
a single short beep and a long beep at 00:00
The Pocket Pro will restart automatically from the pre-defined time of the count-down.
The timer will run and show the full time since the first Start.
To stop the sequence, you have to RESET the Pocket Pro.
