2
1. Read the manual before you use the product
2.
Use the product only as specified, or the protection supplied by the product can
be compromised
3.
Do not position the equipment so that it is difficult to operate the disconnecting
device (appliance inlet of external power supply, equipment input connector)
4.
If fluids are spilled on the product, turn the system off immediately by pulling the power
supply out of the electrical outlet
5.
In case of fire close to the microscope, please turn off and disconnect the system
6.
Avoid subjecting the lens to sharp or hard objects
7.
Please do not connect the microscope, if visible damages appear
8.
Do not dismantle any parts of the microscope, except where noted in the manual
9. Never disassemble or clean internal optical surfaces
10. Use only the power supply provided from TAGARNO
11.
Always turn off the system before unplugging, when possible
WARNINGS
The product is a digital magnifying system consisting of a camera unit, PCBs, mechanical
parts and a power supply. The product is intended for marketing worldwide and is designed for
manual visual inspection.
INTENDED USE
Read all safety information before you use the product.
Please pay attention when you see a warning label on the product.
This product is for indoor use only.
You must not discard this electrical/electronic product in domestic household waste.
Please dispose at your local recycling centre.
1. INTENDED USE
2. WARNINGS
3. TIPS
CAUTION, HOT SURFACE: The inside of the camera head might be hot.
To reduce the risk of injury from a hot component, allow surface to cool before
changing the close-up lens.
12. Do not touch the light source. It gets hot when using the product
13. Do not look directly into the light source
WARNING: This is a Class A product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take appropriate
measures.
1.
Avoid touching the lens glass
