6
7. OPERATION
Power on/off
Short push switches between Iris,
Gain and Preset mode.
Increase Iris/Gain or switch between
zoom preset 1, 2 or 3.
Decrease Iris/Gain or switch between
zoom preset 1, 2 or 3.
To change and save a zoom preset,
use zoom buttons to select a zoom
level and simultaneously press
left/right buttons. OSD will show
STORED: PRE(X)
Hold down for 3 seconds to use
auto exposure mode
RESET TO FACTORY SETTINGS
Follow this procedure to change back to factory
setting 1080P60.
1.
Turn the microscope off
2.
Press and hold the center button down
while turning the power on
3.
Keep holding the center button down for
25 seconds
4.
Release the center button and turn the
power off
5.
Turn the power back on and the
microscope is set to factory setting
1080P60
Multi function buttons. Do only connect
equipment distributed by TAGARNO
Light on/off
OPERATION | CONTROL BOX (1/3)
Zoom in
Zoom out
Push both plus and minus to switch
from auto focus to manual focus.
You can now adjust the focus
manually by using plus/minus
If you wish to focus on something
close
If you wish to focus on something
farther away
TIP!
Find the "How to Use" tutorial video here: www.tagarno.com/usezip
