14
3 + 5
2 + 4
Camera head configuration
To switch between TAGARNO ZAP and TAGARNO
MOVE/FRONT configuration, perform a camera head
configuration.
To start the configuration please follow the steps below.
1. Make sure that the power box is turned on and
connected to TAGARNO ZAP
2. Power of TAGARNO ZAP
3. Press and hold the four arrow keys on top of the
camera head
4. While holding the keys, power on the ZAP
5. Let go of the arrow keys when a popup window
appears
on the screen:
6. In the popup window select the MOVE/FRONT option
- use the arrow keys and center button on the XPLUS
control
box to navigate and select
7. Follow the instructions on the screen and wait until
the
system has completed the change
Revert configuration
To revert back to ZAP configuration, follow steps 1 - 5
above and then continue with steps 6 and 7, while
selecting
the ZAP option in the popup window in step 6.
Zoom
Push this button on the control box to zoom in.
Push this button on the control box to zoom out.
The magnification level will show via On Screen Display.
Manual Focus
Turn autofocus off by pushing both zoom buttons (plus
and minus) on the control box at the same time. You
can now adjust focus manually with the help of the
zoom buttons.
Push this button on the control box to adjust focus if you
wish to focus on something very close.
Push this button on the control box to adjust focus if you
wish to focus on something that is farther away.
To turn the autofocus on again, simply push both zoom
buttons (plus and minus) at the same time.
The focus values will show via On Screen Display.
Multi Function Buttons
Use the Multi Function Buttons to control the iris, gain
and exposure time.
Press the center button to switch between auto and
manual exposure mode. When the On Screen Display is
open, all four arrows can be used for navigating the menu
and adjustment of settings.
The window will automatically close after 3 seconds
inactivity.
Laser on/off
WARNING! Laser radiation when turned on
OPERATION | CAMERA HEAD (4/5)
