english
Taifun® GT III – User Manual
14
Taifun® GT III assembly
1
spring
2
countersunk head screw
3
positive pole base plate
4
positive pole screw
5
positive pole mount
6
isolator (PA)
7
3x spacer
8
O-ring 5x1,5 mm
Pic 1:
The isolator [6] is pushed over the
positive pole base plate [3].
Pic 2:
The isolator [6] must be fully seated
on the positive pole base plate [3].
Pic 3:
On the other side, the three spacers
[7] are attached.
Pic 4:
The O-ring [8] is also pushed over
the isolator [6].
Pic 5:
Push the O-ring [8] as far as possible
onto the insulator [6].
Pic 6:
Then insert the positive-pole screw [4]
into the positive-pole holder [5].
Pic 7:
Screw the screw [4] as far as it will go.
Pic 8:
The screw [4] is now screwed into
the positive pole base plate [3].
Pic 9:
The countersunk screw [2] is now
pushed into the spring [1].
Pic 10:
Push the spring [1] as far as possible
onto the screw [2].
Pic 11:
Put the screw [2] into the positive-
pole base [3] at the bottom.
Pic 12:
Carefully screw in until it stops.
