Chapter 3 Configuration and Management
27
Chapter 3.
Configuration and Management
This Chapter describes the Terminal User Interface provided by VENUS 29xx
Series. There are three methods to access to the Terminal User Interface: the Craft
port, Telnet and Web browser, those present the exactly same format of terminal
management. The Craft port is used primarily when the device is installed for the
first time and the IP configuration is not yet provisioned. Once when the IP
connection is provisioned, user may login to the Terminal User Interface using the
Telnet software or Web browser to remotely control or maintain the device from
anywhere in the global IP network.
3.1
Quick Start
Once when the VENUS 29xx Series is successfully started up, please make sure
that the connection to the IP network is properly installed
before continuing
with the configuration. Very few parameters are required for configuring the
VENUS 29xx to bring up basic VoIP service. Here is a guide for start VoIP service
quickly.
3.1.1
Connecting to Venus 29xx
3.1.1.1
Setup PC
There are five ways to connect the VENUS 29xx, the Web-based management,
Telnet_based management, SNMP_based management, TR069_based
management and the Terminal Emulation-based management. The Web-based
one is recommended.
The connection between PC and VENUS 29xx SERIES as shown in the following
Figure:
Summary of Contents for VENUS 2916
