4
(3)
Reassembly
The screw tightening torque for reassembly should be within the range of “3N ∙ m ± 10%”.
1) Install the fan motor⑧ into the case③ and ghten the screw⑦.
Note: Make sure that the install direction of the fan motor ⑧ (wind direction to the radiator)
is correct as indicated by the arrow on the surface.
Note: Make sure to pull out the fan motor lead wire and ground wire from the hole⑩ on the
case③.
Note: Make sure that the fan blade does not hit the wires inside the case③.
2)
As shown in the exploded view, place the fan guard⑥ with the screw⑦ and the
washer⑤ in order, and tighten them with the nut④.
3)
Install the radiator② and the case③ and tighten them with the screw①.
(4)
Connection
1)
Check the voltage of the fan motor⑧ before wiring.
2)
The wiring diagram is shown on page 5.
Exploded View
(The position of the ground terminal
⑨
may be different by each fan motor.)