LED:
Sound:
steady
pitch:
high
medium
low
flashing
duration:
short
long
... repeating
Message
Meaning
WAIT
The system is setting up a call.
GO
A traffic channel has been allocated for a call. Proceed with the conversation.
ACCEPTED
Your status call, despatcher callback request or network service request
has been accepted.
ENGAGED
The system cannot contact the party you are attempting to call because
they are busy. Try again later.
QUEUED
The network has queued the call you are attempting to make. Your call
will be connected as soon as possible.
SYS BUSY
The network is busy and is unable to handle your call request. Try again
later.
NOT HOME
The party you are calling has their radio switched off, in do not disturb
mode or is out of range. Try again later.
DND
The do not disturb function is active.
QUE
Call queuing is active.
UNAVAIL
Your radio is not permitted to make the type of call you requested.
UNOBTAIN
The call you are attempting to make is not valid for your radio.
Radio
Indicators
Display messages are shown in ALLCAPS, e.g. CALL
Display
Sound
Meaning
+ flashing
The radio is transmitting.
+ flashing
The radio is transmitting at low power.
Low power transmit is active.
slow +
Handset mode is active.
A function has been turned on.
A function has been turned off.
x 3 The transmit timer is about to expire.
The radio has stopped transmitting because the
for 1.5
transmit timer has expired. Release the PTT key
sec
before transmitting again.
slow +
The radio has access to a network and is ready to
make or accept calls.
The radio does not currently have access to a
flashing
network.
x 5
The current operation has been cancelled at your
request.
fast + caller’s ID warble ... A call has been received but not answered. To
return the call, give a brief press of the PTT.
x 3
Your call time is almost up. In 10 seconds, you will
be disconnected and the call will be cleared down.
+ CHAN
Your radio is now operating in conventional mode.
The channel is busy.
You cannot transmit because the channel is busy.
Monitor is active.
slow +
every The battery is low. Recharge or replace the battery
flashing
5 sec
as soon as possible.
The battery is too low to operate the radio. The
radio will automatically switch off. Recharge or
replace the battery.
x 2
The temperature is too high. You should stop
transmitting and allow the radio to cool down.
Basic Oper
ation
T
runking Mode
Warnings
Con
v Mode
