2
T02-00034-EAAA Ignition Sense Cable
© Tait Limited December 2017
Radio Programming
1 Startup/Shutdown form: In the
Power On Mode
field, set how the radio responds
when the radio receives a signal to power on from the vehicle’s ignition signal. Select
either ‘Power On’ or ‘Previous State’.
2 Programmable I/O form (Digital tab): Program the
AUX GPI3 line
to ‘Power Sense
(Ignition)’ and
Active
to ‘High’.
Refer to the online help of the programming application for more information.
Installation
1 Connect the auxiliary connector plug to the radio’s auxiliary connector.
2 Cut the wire where the in-line fuse holder will be placed (as close to the ignition/acc
signal as possible).
3 Using an appropriate crimp tool, e.g. Utilux #102B, insert each end of the wire into
each of the fuse crimp terminals and crimp them to force the metal contacts onto the
wires.
4 Push the crimp terminals into the clear plastic fuse holder.
Notice
Do not install the fuse until the installation is ready to be tested.
5 Connect the fused end of the ignition sense cable to the 13.8V signal controlled by the
vehicles ignition key.
6 Insert the fuse into the fuse holder and close it.
7 Check the ignition sense feature is working correctly.
More Information
Refer to your radio provider for more information about this product.
