Installing a T2000
13
2. Fit the metal cover plate onto the mounting studs. The end
of the cover plate that overhangs the plastic side mould-
ings, must face towards the rear of the supply.
3. Fit the nuts onto the protruding studs and fasten firmly.
Reassemble the T2000 Cradle
1. Position the cradle on the mounted cover plate, taking care
to locate the plastic ribs into their mating slots. They will
not fit if the cradle is back to front.
2. Clip the ribs home. This will require gentle pressure, with
your index fingers on the inside and thumbs on the outside,
as shown below.
Mount the Radio Cabinet and T2000
Radio
1. Position the radio cabinet over the power supply so that the
mounting holes in the radio cabinet line up with the corre-
sponding holes in the power supply.
2. Insert the screws and then tighten all four screws firmly.
3. Slide the radio, heatsink first, into the front of the cradle
until it seats firmly.
cradle outer cover
radio cabinet
cradle metal plate
apply
pressure
apply
pressure
