348
Transmitter Fault Finding (25W)
TM8100/TM8200 Service Manual
© Tait Electronics Limited
June 2006
Task 15 —
Shaping Filter for
Power Control
If neither the voltage nor the current measured in
is correct, then
the shaping filter for the power-control circuitry or the CODEC and audio
circuitry is suspect.
Important
Ensure that the current limit on the DC supply is 2A.
And, when entering the CCTM command
331
x
, do not
specify a value
x
higher than that recorded in
Failure to do so might result in the destruction of the PAs.
1.
Use the multimeter to measure the voltage at the
FIN
1
test point
(see
). The voltage should be:
2.
Enter the CCTM command
331
x
(where
x
was recorded in
3.
Check that the voltage changes to:
4.
Enter the CCTM command
32
to place the radio in receive mode.
5.
If the voltage measured above is correct, go to
. If it is not, go
“CODEC and Audio Fault Finding” on page 381
6.
Check
IC301
and the surrounding shaping-filter circuitry
(see
). If a fault is found, repair it, confirm the removal
of the fault, and go to
. If the repair failed,
replace the board and go to
FIN1 test point: 18
±
2mV (initially)
FIN1 test point: 1.1 to 2.7V (after entry of CCTM 331
x
)
Summary of Contents for TM8235
