TM8100/TM8200 Service Manual
Frequency Synthesizer Fault Finding
205
© Tait Electronics Limited
June 2006
Task 17 —
Check Receive VCO
Check that the correct receive frequency is synthesized. This is the
frequency of the receive VCO output
SYN
RX
LO
1
at the
RX
port shown in
.
1.
Enter the CCTM command
335 0
to set the transmit-receive switch
off (receive mode).
2.
Using a frequency counter, proceed as follows to observe the receive
frequency at the
RX
port before and after grounding the junction
between
C541
and
R547
(see
While holding the probe from the counter on the
RX
port, use a pair
of tweezers to momentarily ground the junction. The frequency
should change to:
The loop filter will hold its output steady at 13.3 V. This should result
in a frequency equal to the maximum given in
3.
If the receive frequency measured in
is correct, go to
If it is incorrect, go to
, but if no frequency is detected, go to
4.
Proceed as follows to observe the receive frequency at the
RX
port
before and after applying 3 V DC to the junction of
C541
and
R547
;
there is a convenient 3 V level at
R544
(see
While holding the probe on the
RX
port, use the tweezers to
momentarily apply 3 V DC to the junction; do not touch the board
with your hand, and do not allow the tweezers to touch any cans
when you remove them. The frequency should change to:
The loop filter will hold its output steady at about 0V. This should
result in a frequency equal to the minimum given in
5.
If the receive frequency measured in
If it is incorrect, go to
. If no frequency is detected, go to
RX port: maximum receive frequency (see
)
RX port: minimum receive frequency (see
Summary of Contents for TM8235
