336
Transmitter Fault Finding (25W)
TM8100/TM8200 Service Manual
© Tait Electronics Limited
June 2006
Task 6 —
Power Unchanged
Regardless of
Setting
If all the power and current values measured in
are correct, it is likely
that the power remains unchanged regardless of the power setting.
1.
Enter the following CCTM commands in turn and measure the RF
output power in each case:
■
326 4
■
326 3
■
326 2
■
326 1
2.
The above measurements should confirm that the power remains
unchanged at all settings. Carry out
Task 7 —
Check for Inhibiting
of Transmitter
If the transmitter is drawing no current or the wrong current, check
whether it is being inhibited. This check is also required if a
CO3
error
occurs in
1.
If not already done, enter the CCTM command
33
to place the radio
in transmit mode.
2.
Check the logic signal at the
TX INH
test point
(see
The signal should be:
3.
If the signal is inactive as required, go to
. If it is active — about
1.1V — the transmitter is being inhibited; go to
4.
Enter the CCTM command
32
to place the radio in receive mode,
and go to
in
“Biasing of PA Driver and PAs” on page 342
5.
Check the logic signal at the
D TX INH
test point
(see
The signal should be:
6.
If the signal is inactive as required, go to
. If it is active — about
3.2V — the temperature sensor is suspect; go to
.
7.
Enter the CCTM command
32
to place the radio in receive mode,
and go to
8.
The lock status is possibly no longer normal. Enter the CCTM
command
72
and check the lock status.
9.
Enter the CCTM command
32
to place the radio in receive mode.
10.
The normal lock status is
110
. If it is not, proceed to the relevant
.
11.
Check for short circuits on the
DIG
TX
INH
line from the
D TX INH
test
point
.
TX INH test point: about 0V (inactive)
D TX INH test point: about 0V (inactive)
Summary of Contents for TM8235
