22
Installing a Dual-Radio System
TM8260 Installation and Programming Guide
© Tait Limited
October 2014
Removing the Body
Interface
1.
On the underside of the
radio, insert a 5mm (3/
16in.) flat-bladed screw-
driver between the body
interface and the seal, in
the positions shown
(
Insertion points and are
lever points and are indi-
cated on the radio chassis
by a dot-dash-dot pattern (•
–
•).
Notice
Take care that the seal is not damaged. Damage to this seal
reduces environmental protection.
2.
Use the screwdriver to lift the remote interface off the chassis clip,
then repeat in the other position.
You should now be able to inspect, and if necessary remove, shorting
link J4. It is not necessary to remove the body interface loom or the
earthing tag to remove the link.
Assembling the Body Remote Interfaces
The following steps show how to connect a body remote interface to a radio
body. Complete these steps for both radio bodies.
One remote interface must have link J4 removed. See
for more information. After you install the interface with
link J4 removed, make sure you can identify that radio body when con-
necting the cables afterwards. If necessary, mark the radio body with an
appropriate label or similar.
1.
Screw the earth-
ing tag onto the
left screw boss on
the radio chassis,
using the Torx T-
10 screw pro-
vided.
Figure 3.6 Removing the body interface
lever point
seal
indication of
lever point
