TM8260 Installation and Programming Guide
Installing a Dual-Radio System
23
© Tait Limited
October 2014
2.
Plug the body-
interface loom
onto the control-
head connector.
Notice
When
mounting the con-
trol head, make sure
you do not pinch
and damage the
loom.
3.
Insert the bottom
edge of the
control head
onto the two
clips in the front
of the radio
chassis, then snap
into place.
Mounting the Radio Bodies
Mount the two radio bodies less than 1.5 metres (4.9ft.) apart using the
preferred mounting method (such as U-brackets, slide-in cradles, or security
brackets).
For more information, refer to the instructions included with the cradle or
bracket installation kit.
Installing the Radio Connecting Cable
contains an overview of the connections between both radio
bodies and the control head. For information on the pins and signals of all
ports, see
.
Figure 3.7
Overview of connections between radio bodies and control
head
outermost
port
body with link J4 fitted
body with link J4 removed
innermost
port
radio connecting cable
TMAA04-03 (1.5 m / 4.9 ft.)
to control head
solution
outermost
port
innermost
port
