TM8260 Installation and Programming Guide
Preparing the Installation
15
© Tait Limited
October 2014
2.6
Removing and Installing Grommets
Grommets ensure that the radio system and all connections are sealed against
water, dust and other environmental hazards. A dual radio system requires a
grommet in the unused remote-interface port (item
g
in
). A dual radio system also requires all cable grommets to
be installed.
Removing a
grommet
1.
Using your thumb or forefinger, lift up one of the corners of the
microphone grommet. Firmly (but gently) pull that corner until the
seal comes away from the cavity. See
Figure 2.2
Removing a grommet
2.
Repeat to expose another corner.
3.
Pull the exposed corners back and remove the grommet.
4.
If removing a cable grommet, slide the grommet along the cable to
reveal the plug.
Installing grommets
5.
If installing a cable grommet, slide the grommet along the cable.
6.
Push two adjacent corners of the grommet into the socket cavity.
7.
Squeeze the grommet and push the remaining corners into position.
8.
Check that the grommet is seated correctly in the cavity.
See
.
Figure 2.3
Correct seating when installing a grommet
gromm
