Operating in conventional mode 79
The green LED stops flashing, and the monitor
icon disappears from the display.
Using the function key programmed for reset
monitor/call cleardown to end active calls
The function key programmed for reset monitor may
be programmed so that a short key press ends your
current call, and a long key press ends all active calls
in your group.
Using monitor and squelch
override (on analog channels)
The monitor function allows you to override some or
all of the radio’s mutes, and hear if there is any traffic
on a channel before you make a call.
The squelch override function lets the radio user
override the squelch (carrier) mute and hear all noise
on a channel, including weak signals that are below
the programmed squelch threshold.
Your radio may be programmed to activate
monitor whenever the microphone is off the
microphone clip.
To turn monitor on and off:
1
Press
Menu
and select
Radio settings
>
Functions
>
Monitor
.
(Depending on how your radio is programmed, you
may be able to press a function key to toggle
monitor on and off.)
2
Scroll to
On
(or
Off
) and press
Select.
While monitor is on, the green LED flashes slowly
and the monitor icon appears in the display.
Your radio may be programmed so that monitor
turns off automatically after a short time.
Summary of Contents for TM9355
