M2259-00-200-812
Midian Programming
79
Copyright TEL
Encrypted Radio Programming and Service Manual
7
Midian Programming
To program Midian Encryption Modules fitted to either a T2000 or a TOP radio usually requires
a hard-wired connection from the Midian programmer to the module. This requires opening the
radio and connecting the dedicated programming cable (provided with the Midian programmer)
to pads on the Tait flex circuit.
Note:
TOP radios fitted with Midian TVS2-Tait Encryption Modules and using -07 version
encryption flex (or later) can be programmed without opening the radio, using TOPA-
EA-007G Direct Programming Cable. Instructions for TOP TVS2-Tait Module Direct
Programming are on page 81.
Refer to the Programmer and Module service manuals for specific information on module
parameter settings and values.
Note:
Some link settings and functions on the modules may be for future use, or require
special setup or additional components to operate. If a function is not documented,
please ask for assistance before using it.
TVS2-Tait Over-the-Air Programming (TOP and T2000 radios)
The Midian TVS2-Tait Encryption Module can be remotely programmed to change encryption
code. Contact your Tait Service Centre for more information.
TVS2-Tait Direct Programming (TOP radios only)
A TOP radio with Midian TVS2-Tait Encryption Module and using -07 version encryption flex
(or later) can be direct programmed without opening the radio, to change any of its
programmable parameters. To utilise this feature, you require a dedicated direct programming
cable TOPA-EA-007G (see page 86 for more information).
Note:
This cable is
not
part of the Encryption Programming and Service Kit and must be
ordered separately from your Tait Dealer.
7.1 Circuit
Operation
The programming software on the PC sends data down the standard serial cable to the
programmer, which is hardwired to the module microcontroller via pads on the TOP or T2000
Encryption Upgrade Flex.
7.2
Programming a Midian Encryption Module (Hardwired)
Note:
See page 81 for information on direct programming a TOP radio with TVS2-Tait and -
07 version (or later) flex using TOPA-EA-007G Direct Programming Cable.
Equipment
PC with serial port, and if necessary 25pin D-range plug to 9 pin D-range socket adaptor.
Midian KL3 programmer (including programming cable).
Midian software to suit the module to be programmed.
TOP or T2000 radio to be programmed with flex and module fitted
