Midian Encryption Programming and Service Manual
Midian Encryption
19
June 2006
© Tait Electronics Limited
TVS2-Tait Over-the-Air Programming
The Midian TVS2-Tait Module encryption code can be remotely changed.
Contact your Tait Service Centre for more information.
TVS2-Tait Direct Programming
A radio with Midian TVS2-Tait Encryption Module can be direct-
programmed without opening the radio, to change any of its programmable
parameters. This requires a dedicated direct programming cable as follows:
■
TOP radios use 219-02931-0X (see Cable Specifications
on page 25
)
■
TM8000 radios use 219-03026-0X (see Cable Specifications
on page 25
)
Note
The Midian KL3 programmer includes a dedicated programming
cable. However, as this cable requires the radios to be opened, its
use is not recommended or supported by Tait.
Direct Programming
Method
Equipment
■
PC with serial port, and if necessary 25pin D-range plug to 9 pin D-
range socket adaptor.
■
Midian KL3 programmer (supplied cable not required).
■
Midian software to suit the module to be programmed.
■
TVS-2 encrypted TOP or TM8000 radio to be programmed
■
Encryption Direct Programming Cable 219-02931-0X (TOP) or 219-
03026-0X (TM8000)
Setup
connect cable to
15way D-range
on radio rear
TM8000 Encryption Direct
Programming Cable
Connect cable to TOP
accessory connector
TOP Encryption Direct
Programming Cable
RS232 serial cable
(not provided)
or
